Why is my ET gate motor beeping?
In theory, this means that they can operate sans mains power. In the event of a power failure, for example due to load-shedding or the power supply (charger) being damaged by, say, lightning, your CENTURION gate motor will periodically emit two short beeps until power is restored.
Why is my electric gate opening slowly?
If your system runs on a battery, it could need replacing. The battery should be around 13.8 volts fully charged and drop no less than a volt under load. Batteries with a lower voltage will cause the gate to run slower if not fully charged.
Why is my gate motor not working?
If your gate simply isn’t working, it could be due to an electrical outage. Check that the gate is still receiving power. If it is, your remote control may simply need new batteries. If that’s not the issue, manually check the door to see if it slides or swings freely or if there’s something preventing it from moving.
How do you charge a gate battery?
The motor of the gate is powered by a gate motor battery. This battery can be charged by either connecting it to the mains via the gate controller’s charging system or even a solar power system. If you have access to the main power supply then this is a viable and popular power source option for your gate motor system.
Are there any manuals for the Etet gate motor?
ET Gate Motor Manuals | ET Drive 300 Manual | ET Drive 500 Manual | ET Drive 600 Manual | ET Drive1000 Manual | ET 500 Plus Manual | Latest gate Manuals. Available are the following manuals to make it more convenient for the setup or faulting finding of your gate motor.
What is the warranty on an et-500 12V motor?
Page 1 ET-500 AUTOMATIC SLIDE GATE MOTOR USER’S MANUAL FOR ET-500 12V & ET-500 ACDC MODELS REVISED DATE: May 2006… Page 2 ONE-YEAR MANUFACTURER’S WARRANTY · All goods manufactured by G & C Electronics cc t/a E.T. Systems carry a 12 month factory warranty from date of invoice.
Who makes Etet drive 500/600 user?
ET DRIVE 500/600 USER 2016.001.001 End User Instructions High Traffic Low Traffic 500kg Slide Gate Operators Designed, manufactured and supported by ET NICE (Pty) Ltd Nice Page 2 Introduction. Page 3 Be Safe!
What maintenance is required for the et-500?
The ET-500 is designed to be maintenance free. However, there are some basic installation checks that should be carried out regularly (every three months) which will increase the long term reliability of your equipment and prevent intermittent operation. NB: ISOLATE MAINS SUPPLY TO SYSTEM BEFORE CLEANING OR WORKING ON THE EQUIPMENT 1.
